Steve Maskery
Established Member
Yes, I'm seriously thinking of it.
You see, I'm a lucky little so-and-so, I have 2 x 1.4m rails and a 2.7m rail. Since getting the 2.7 I've never needed to join the two shorter ones, and, as is being discussed in another thread right now, you do have to take care to ensure they are perfectly in line (I wasn't aware that there was a later version, Keith, that's helpful to know).
So I'm thinking of cutting one of my 1.4s into a 900 and 500, which would be handy when I'm prepping large rough sawn boards outside prior to getting them inside to the machinery.
Can I do this safely on my SCMS? It has an 80T (I think) TC blade.
Any help gratefully received.
Cheers
Steve
You see, I'm a lucky little so-and-so, I have 2 x 1.4m rails and a 2.7m rail. Since getting the 2.7 I've never needed to join the two shorter ones, and, as is being discussed in another thread right now, you do have to take care to ensure they are perfectly in line (I wasn't aware that there was a later version, Keith, that's helpful to know).
So I'm thinking of cutting one of my 1.4s into a 900 and 500, which would be handy when I'm prepping large rough sawn boards outside prior to getting them inside to the machinery.
Can I do this safely on my SCMS? It has an 80T (I think) TC blade.
Any help gratefully received.
Cheers
Steve