Router table levelling screws

[Glynne]

This is related to the Router Insert Plate thread but I thought I'd post separately to go for a wider audience.
Simply, what are the levelling adjusting screws called and where can you get them.
I know they are threaded inserts with enclosed Allen screws but does anyone know where I can get 8 of them please?
Thanks.

 

[paulrockliffe]

I used M8 grub screws, I just searched for them on eBay and bought a handful.

 

[marcros]

same here. they may have been m6, but same principal.

 

[JJ1]

I think they're also known as set screws. I bought a pack of assorted sizes from e-bay. Just a couple of quid if I remember rightly. I embedded a coin type battery beneath each one to give them something solid to bear down on.

 

[Steve Maskery]

If you have some tiny magnets, embed them in the top, underneath the screws. It stops them vibrating loose, over time.
S

 

[Glynne]

Thanks all.
No problem in finding the set / grub screws but I'm struggling to find some inserts for them to go in. Difficulty is that I only need a depth of about 6mm (as per the Rutlands insert plate) so any suggestions would be welcome.

 

[Myfordman]

Why do you need inserts? Just tap the plate with the correct thread for the screws.

 

[Glynne]

Why do you need inserts? Just tap the plate with the correct thread for the screws

If I had a brain I would be dangerous! So busy trying to duplicate the plate I have that the chuffing obvious didn't occur to me.
Thanks.