Remote Dust Extraction Wiring

[Daniel.l]

MOD EDIT : EARLY POSTS CONTAIN ERRORS IN WIRING DIAGRAMS. SKIP AHEAD AND READ THE LAST POST FIRST.

Hi all,

I need some help with wiring a remote started bought from Tough Leads. So first off I have a felder af22 dust extractor. This extractor has a manual motor starter and this wont work with the remote system. So I was advised to purchase a DOL starter.
So, I now have the DOL starter and the remote system which I need to wire up.
The remote system comes with instructions and I understand them mostly however, it is the DOL starter that is confusing me.
I have drawing out a wiring diagram (see below) of how the DOL started was wired out of the box. There are two wires on the left of the diagram coming from A1 (green) and 3/L2 (red) and I am not sure what they are supposed to be connected to?

I have not attempted to wire anything up yet and this is my attempt on paper,

The way I have this wired may not be the best way to do it (suggestions would be appreciated) sorry about the scribbles I made a mistake on bullet point 4 of step 4.

Pictures of DOL starter

 

[Daniel.l]

I realised while wiring it up that I have forgot to add the plug to the diagram and that I had the neutral completely wrong.

 

[Daniel.l]

To close this thread off. I was sent a DOL started from Tough Leads without a thermal overload relay. This should have been included in the order which I am quite disappointed about. I contacted CHINT the brand of the DOL starter and were very helpful. Here is a diagram of there wiring if anyone else runs into this bother or is trying to wire a Chint DOL starter. Please do not follow my wiring diagrams above they are wrong.