Hi
Is there a general level of tolerance for how coplanar the infeed and outfeed tables on a planer thicknesser should be when set to zero. My machine is coplanar to within 0.15mm. My gut feeling is that this is adequate. Im guessing it can’t be as flat as hand place as the surface area is significantly bigger. Am i correct in this?
Thanks in advance.
Is there a general level of tolerance for how coplanar the infeed and outfeed tables on a planer thicknesser should be when set to zero. My machine is coplanar to within 0.15mm. My gut feeling is that this is adequate. Im guessing it can’t be as flat as hand place as the surface area is significantly bigger. Am i correct in this?
Thanks in advance.