Noob question on router bits for finger joint jig

[blackbulldog]

Someone gave me a jig for making finger joints. It's made from pine and looks like the pic attached.

The gap between the fingers is 12mm. Is there a router bit (flush trim??) that will fit into that gap and fit into a trim router?

I've looked and they all seem to be 12.7 mm or larger.

Thanks.

 

[__jvc26]

https://www.wealdentool.com/

 

[Phil Pascoe]

Good as Wealden are I doubt they do the required cutter with a 12mm shank/bearing. Worth searching, though.

 

[blackbulldog]

Good as Wealden are I doubt they do the required cutter with a 12mm shank/bearing. Worth searching, though.

I'm not sure what you mean by 12mm shank, I only have a Ryobi trim router with a 6mm collet.

 

[Phil Pascoe]

Ah, yes. You need to find a 12mm bush and the correct diameter cutter. (Assuming you can fit bushes to a trim router, I know nothing about them.) Be careful you don't buy 1/4" bits for a 6mm collet.

 

[Spectric]

Assuming you can fit bushes to a trim router

You can to the Bosch GKF 600 so I would think others would accept as well.