You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support UKworkshop.co.uk:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
G
I have had a Creality K1 for a few months and it is superb, this is my third 3D printer and by far the best and far cheaper than the...
-
G
Just design it with a 10mm/12mm threaded hole down the centre with a countersunk hole and screw in a machine screw or similar to give it...
-
G
Print a case for my tap & die set.
I had to split each component in two just so it would fit on the printer bed.
-
G
Cut a sign from accoya panel, had to stain the wood as there was an ugly board on the centre of the panel, 3 ft by 2 ft by 2 inch thick
-
G
Laser cut some clear acrylic trays for my recent coffee station, acrylic is not very forgiving, got the thickness slightly wrong and...
-
G
Post cappings for oversized 145mm balcony posts. Inset underneath to fit post and drip groove that works well. Modelled in Fusion360 and...
-
G
Another quick print today. I bought a length of diffuser extrusion for LED light strips top go under the wall units in my daughters...
-
Loading…
-
Loading…