My workshop (garage) and some more TS mods.

[Ateallthepies]

Got ya, ta.

Will knock up some guards tomorrow.

I may also take my unused band saw mitre fence and stick it on the router table and I still got to make a support for the out-feed table.

Steve.

 

[Noel]

Good point on the guarding. Steve you said put a box on the rear but did you mean the front bit that faces me?

Steve.

Not sure about putting a "box" on a sled. Accepted practice is a solid block of wood. This acts as guarding and if needed let's you know when the work piece has passed the blade as the blade meets the block of wood.

As mentioned some transparent guarding the length of the sled would make sense.