This is how I made it :mrgreen:
Start with blank on a 4" face plate
.
Start to shape bottom
.
Include chuck spigot
.
Sanding sealer and polish
.
Reverse onto chuck
.
True up front face and hollow bowl section
.
Mark out 8 divisions
.
Drill holes and cut slots by hand with a fretsaw
.
Sand each division buy hand
.
Mask out divisions to be dremeled with a rotary burr
.
Ebonies with Chestnut spray
.
Clean up fluffy bits with a radial bristle brush
.
Pyro the rim
.
.
.
1 section laced with silvered copper wire
.
Reverse onto Cole jaws and remove the spigot
.
and end up with this :mrgreen:
Thanks for looking :wink:
Start with blank on a 4" face plate
.
Start to shape bottom
.
Include chuck spigot
.
Sanding sealer and polish
.
Reverse onto chuck
.
True up front face and hollow bowl section
.
Mark out 8 divisions
.
Drill holes and cut slots by hand with a fretsaw
.
Sand each division buy hand
.
Mask out divisions to be dremeled with a rotary burr
.
Ebonies with Chestnut spray
.
Clean up fluffy bits with a radial bristle brush
.
Pyro the rim
.
.
.
1 section laced with silvered copper wire
.
Reverse onto Cole jaws and remove the spigot
.
and end up with this :mrgreen:
Thanks for looking :wink: