During buying my new (used) table saw (see other link) i also bought the Leigh D4 jig which the owner was looking to sell. Don't know why i did but..... it was cheap.
i have the big Triton router and the guide bush kit and am looking to do some dovetail test pieces. The jig came with 3 8mm shank cutters.
Do i only need to get a 1/2" to 8mm reducer collet to start using the jig?
If so where should i buy from? Axminster...?
Thanks for any advice
i have the big Triton router and the guide bush kit and am looking to do some dovetail test pieces. The jig came with 3 8mm shank cutters.
Do i only need to get a 1/2" to 8mm reducer collet to start using the jig?
If so where should i buy from? Axminster...?
Thanks for any advice