dannythe red
New member
Is there a oin type vice to hold various sizes od drill for a draper 3.5 volt drill
I am really old 84 and have been making inch thick wooden jigsaws for some 5o years and am really good at it. Usd to sell in covent garden markt sat
- Thread starter dannythe red
- Start date
Help Support UKworkshop.co.uk:
I asssume that's pin type vice. You can get chucks for dremels, whether one would fit you'd need to find out.
Lons
Established Member
Hi Danny
There are loads of pin vices available that would do the job e.g. here is a cheap set of 4 ............. Amtech 4 Piece Pin Vice Set - Machine Mart - Machine Mart but that's assuming that your Draper drill has a standard type chuck. If it's the type that takes a hex bit direct into the drive end then you will have to look a bit harder.
Have you googled pin vice?
There are loads of pin vices available that would do the job e.g. here is a cheap set of 4 ............. Amtech 4 Piece Pin Vice Set - Machine Mart - Machine Mart but that's assuming that your Draper drill has a standard type chuck. If it's the type that takes a hex bit direct into the drive end then you will have to look a bit harder.
Have you googled pin vice?
Hello Danny and welcome - I hope I’m still going at 70 let alone 84 . 
Hi and welcome , Any photos of your puzzles .
stuart little
Established Member
Yes, there is a very small 3-jaw chuck with a 2.3 mm shank to fit small collet drills, I have one from ebay. If it was for a Draper 12v motor tool, then Dremel ones fit.
Teepeg
Established Member
Welcome Danny, wouldn't mind seeing some of you finished work .. 
