You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support UKworkshop.co.uk:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
T
Hi Phil and Chailatte
Thanks for the info. I will look at both suggestions.
My chuck is a Toolmex supplied by Axi. The plate is rear...
-
T
I am looking for a chuck backplate to fit my Axminster supplied Toolmex 100mm chuck. The thread needs to be: 1.5" x 8tpi. This is to fit...
-
T
Hi JWP,
just saw your message.
With regard to the panel and gears inside there is info on the lathes UK site about a back gear system...
-
Loading…
-
Loading…