guyos
Established Member
Well at last I have built an adjustable finger joint jig, and it looks quite good.
I used plans now from shopnotes.
Question: If I am cutting the piece on the router and need to make two 1/4" passes, should I complete each slot to depth before moving to the next one, or could I cut all of them to 1/4" depth then reset to the finish depth and go over all of them again? which is more accurate?.
guyos
I used plans now from shopnotes.
Question: If I am cutting the piece on the router and need to make two 1/4" passes, should I complete each slot to depth before moving to the next one, or could I cut all of them to 1/4" depth then reset to the finish depth and go over all of them again? which is more accurate?.
guyos