louis
Member
i have an eunemia m50l/600 (radial) arm saw.
when i cut two pieces of wood or mdf, lay them on a flat surface and butt them toghether, there is a very small gap between the pieces on the surface.
when i turn the pieces upside down the same happens.
it looks as is the cuts are convex.
what can be the reason for this?
blade: cmt z=64 220x30x3.2
when i cut two pieces of wood or mdf, lay them on a flat surface and butt them toghether, there is a very small gap between the pieces on the surface.
when i turn the pieces upside down the same happens.
it looks as is the cuts are convex.
what can be the reason for this?
blade: cmt z=64 220x30x3.2