fraser
Established Member
Hi there,
I've been given a job to make some boxes out of several timbers, 3 in each from walnut, oak, beech, cherry, etc. Basically the finished size is 140 wide by 10mm thick so what i want to do is deep cut a 6x2 board so that i can get three from each. However before when I've tried this I've cut and left it to settle and the wood has cupped too much for me to finish at 10mm. Has anyone got any advice, tips or ways to get round this this time please? Any help appreciated!
Many thanks!
I've been given a job to make some boxes out of several timbers, 3 in each from walnut, oak, beech, cherry, etc. Basically the finished size is 140 wide by 10mm thick so what i want to do is deep cut a 6x2 board so that i can get three from each. However before when I've tried this I've cut and left it to settle and the wood has cupped too much for me to finish at 10mm. Has anyone got any advice, tips or ways to get round this this time please? Any help appreciated!
Many thanks!