Commemorative Oak Table WIP

[srt]

This little project is a bit different so I thought I would share it as I havn't had time to do any WIPs recently.
.

When you cut your tenons with the RAS do they need to be cleaned up with a shoulder plane or do they meet without any trimming?

 

[Dodge]

They are usually clean enough to glue straight from the RAS as long as your blade is in good condition.

Sorry that I havnt finished this WIP as have been manically busy over the last couple of weeks but will try to get done later today when I get home. The table is all finished apart from fitting the front brass plaque that the client has failed to provide as yet!!

Customers :roll: :roll:

 

[Chems]

Dodge, looking forward to seeing the finished item. Did the customer get charged extra for the change to the design? Must have cost you time and materials.

 

[Gerard Scanlan]

Another inspirational WIP.

Regards,

Gerard