Deadeye
Established Member
My Record Power BS350 has a 4" dust port and I have a HVLP sucking away via a cyclone.
The drive belt has broken, and while I've got the wheel off, should I remove the plat that mostly obscures the port? Or is it designed to try to spread the effect across the drive area rather than just hoovering out the bottom?
If it is sensible to remove, any advice on how? I don't think I can get at it with an angle grinder.
Or should I just drill a load of holes in it?
The drive belt has broken, and while I've got the wheel off, should I remove the plat that mostly obscures the port? Or is it designed to try to spread the effect across the drive area rather than just hoovering out the bottom?
If it is sensible to remove, any advice on how? I don't think I can get at it with an angle grinder.
Or should I just drill a load of holes in it?