RogerBoyle
Established Member
Morning Guys
I'm just about to head off to the Nuneaton store to return my edgebander for the techs to have a look at it as I have two issues with it
1. Machine not spreading the glue along the full height of the banding if I go more than 3m per minute which is almost the slowest setting
2. Banding is creeping up as you apply it to the edge of the worktop. It starts off with an even overhang top and bottom but by the time I get to the end of the worktop (600mm Edge) it is leaving the underside exposed by 1 or 2 mm this is a standard 600mm, 40mm thick Kitchen worktop
Has anybody else had any of these issues if so how did you fix them LOL
I've tried adjusting temp to 183 and full glue flow but no matter where I put the settings it seems to be constant in its refusal to work properly.
My other Problem is I've got a big job for me starting a week on Friday and I have over 1100 meters of edging that I need to apply and I really do not want to use an iron LOL
I'm just about to head off to the Nuneaton store to return my edgebander for the techs to have a look at it as I have two issues with it
1. Machine not spreading the glue along the full height of the banding if I go more than 3m per minute which is almost the slowest setting
2. Banding is creeping up as you apply it to the edge of the worktop. It starts off with an even overhang top and bottom but by the time I get to the end of the worktop (600mm Edge) it is leaving the underside exposed by 1 or 2 mm this is a standard 600mm, 40mm thick Kitchen worktop
Has anybody else had any of these issues if so how did you fix them LOL
I've tried adjusting temp to 183 and full glue flow but no matter where I put the settings it seems to be constant in its refusal to work properly.
My other Problem is I've got a big job for me starting a week on Friday and I have over 1100 meters of edging that I need to apply and I really do not want to use an iron LOL
