Search results

dry wall adhesive, sets quite quickly, say 1 hour

I had 1050st sprint doing 150 on the clock at the Nurburg in 2012 :-)

As said in an earlier reply, its the hot steam that causes damage, any good varnish should do the job

Careful, if you pad out the base units, make sure your worktop is wide enough, have you thought about building 1 wall out 30mm to make the room the correct size? Walls are never square in my expeience so I would leave the walls alone and place a 15mm infil between the base and wall units

I can vouch for mint

I set mine up using this guys method. https://www.youtube.com/watch?v=wGbZqWac0jU

Thanks for this

cross cut sled, always in use

Hopefully going Sunday

http://www.timbercut4u.co.uk/shop/produ ... PzXxuFdOy8 via ggogle

I carry this setup in my van for cutting large panels, (and smaller ones) with my track saw , it sits on top of 2 tressels it knocks down small. Its approx 1m wide and 1.8m long

If you have a circular saw make a tracksaw out of it https://www.youtube.com/watch?v=ZtlxOQrXhEo

The best thing i ever did to my transit was to raise the floor and build in 150mm deep drawer, 2 at the back and 2 more for the side door, access to all my fittings and occasional used tools without loosing floor space. Power tool rack access thru side door, i park tight to a fence at night :-)...

there are sites that give you 10 minute email accounts, perfect for sites that you just want to visit once and not get spammed. http://10minutemail.com/10MinuteMail/index.html

I would have been interested in your offer and Bobs, but Im smack in the center of England, too far from either. :-(

Combi boiler or low pressure system (hot water tank)?

Could you add a photo of the pile, it may encourage interest.

i was bought a GoPro for my birthday, base verwsion but picture is great, even in low light

A full cad program called draftsight is free, although not 3d, but then the council wont want 3d, i produced my own ready for the arcitect. http://www.3ds.com/products-services/dr ... -download/

Try this guy, Mike Waldt, he has a playlist for beginners. https://www.youtube.com/channel/UCI_tt3 ... B8ebtB4k1w