Recent content by shinken

and i would also be interested bud!

does any know if the blades that fit this http://www.axminster.co.uk/recno/1/prod ... -21247.htm Also fit my Nobex proman saw? The blade length's are the same but are the holes in the same place? Thanks in advance, Ash

Thanks mate, anyone have one of these http://www.axminster.co.uk/product-Axmi ... -21248.htm Any Good?

Hello Chaps i am after a compound miter saw (the un-powered variety) I know that the nobex ones are very highly rated, but there are hundreds of cheaper ones available. Now my suspicion is that they are cheap for a reason. But does anyone have one that is actually good? i am on a budget :(...

Cheers chaps ill either do that or find a old drill press gut it and make a case to mount it upside down

So it would be possible to use a carrol if i used a tap set to thread it?

Unless anyone else knows of a bobbin sander in whick you can change the bobbins it looks like ill have to make my own machine then :D

Yup those are the ones but i would they fit in a bobbin sander do you know? Does anyone have a bobbin sander that would allow you to fit them? Thanks again!

Does anyone know if bobbin sanders come with chuck mounted bobbins? Basically i wand to make a bobbin on a lath that can use abrasive strip rather than sleeves. Any ideas which machines would best be modded for that? Thanks in advance

Thanks mate i appreciate your help! what exact polyurathene product would you reccomend?

cool thanks guys, your advice has led me on a bit of a search. Found this, would it be suitable? http://rover.ebay.co.uk/rover/1/710-673 ... dZViewItem

Here are some pics of said floor, Sorry about quality (camera phone)

As above the mother in law has a scratched solid oak floor (deep scratch) I am not sure what the finish is, is it best to sand the scratch out only or sand the entire floor and then finish? What would you recommend to finish the floor?

Thanks mate, looks quite hefty though i may go with the pwercap

Hi all i am looking for a powered respirator such as the trend airsheild or pwrcap around the 200 pounds mark is the budget, anyone have any reccomendations? Will be used for turning eventually and powered sanding and some routing Cheers