Recent content by Sawdust

Graham, I don't know much about plumbing but my house has 15mm pipe from the stopcock onwards and we don't have any problems with it. We have 5 sinks and two showers in the house; it's not noisy and we've never noticed any problems running two showers at once. Mike

Absolutely amazing work

Hi Steve, It just goes to show, I should read signatures! I like the look of you bandsaw jig, very clever and I think I'll make one. It looks a lot safer than any of the tablesaw jigs I've seen (I haven't seem yours yet so please don't think I'm suggesting it's unsafe!). If you ever get...

I get the feeling you don't like it! What would you recommend instead? Cheers Mike

I just saw this on offer http://www.rutlands.co.uk/cgi-bin/psPro ... i?promo=23 It looks pretty solid but does anyone have any experience of it? I know the guard needs removing from the saw! Thanks Mike

Bob, I had a similar problem with simliar face frames in a kitchen and I just did this: I used Hettich Sensys soft close hinges which have loads of adjustment and the doors line up perfectly. Cheers Mike

Hi, Thanks. I got the runners and the stainless steel slide from Isaac Lord. This is the basket http://www.isaaclord.co.uk/productDetai ... 45/546/567 it was pain to fit and get the door straight but it works well. The runners are Blum TANDEMBOX Drawer Runners...

Hi, If you look closely at this picture you can see that I fitted wooden shims to the carcass which matched the 'overhang' of the face frame so the runners are flush with the edge of the face frames. I just used offcuts and planed them to fit as they are invisible when the drawers are fitted...

There's one vote for a 5ft ceiling - I'd love to see that workshop!

Thanks very much. Unfortunately, I drew all the plans ages ago using Coreldraw and I can no longer run it because I'm now using Windows 7. If I do manage to get it to run I'll get some copies and send you them. If it helps, I'll describe the construction instead: The carcass sides, bottoms...

I did make the wall unit but a long time ago and regretted fitting butt hinges because the doors swing all over and always seem to bang closed. Also they needed magnetic catches as well which never seem to work very well. I might well make new doors for it as one of them has warped and if I do...

I think I ended up thinning it by about 10%. The Earlex spray kit comes with a viscosity cup and I just thinned until it drained through it about 40secs. Cheers Mike

Thanks very much. Yes, it's tulip wood frames and MR-MDF panels. I bought the Earlex HV5000 set-up and used the standard nozzle, The paint is water based Farrow and Ball. I never made a booth, just covered everything in plastic sheeting from Screwfix. The HVLP setup really doesn't make...

£35,000!!

Well I finally got it finished so here are a few pics The worktops are solid oak with the addition of about 10,000 coats of Danish oil. It's not quite finished in this picture as the pan rack at the left now has a shelf underneath and racks for the lids Internally all the cupboards are...