I have a Relax R2 in my garage/workshop, it is situated about a foot away from the outside brick wall with a straight flue up through the roof. The first two parts are single skin vitriol and the last piece galvanized with a chinamans hat. The connection through the roof tiles is with the...
Roger
If the LOYL was reversing out of the space to straighten up to park correctly within the lines, then the other car must have seen her trying to park. In my opinion the other driver was too impatient to allow your missus to park correctly, and was too close or tried to drive past without...
Almost blitzed my sanity and my whisky supply, plus the dog wanting to go out for w***, spoiling concentration but giving me a break.
Also agree its the Germans giving us a problem again.
Les
Bob
I hate to disagree with you but my sip 01332 3HP table saw runs quite happily of a 13 amp plug. One of the reasons why the fuse will blow on start up is that the drive is too tight. If the machine is belt driven the usual cause is that the belt drive is too tight, requiring more amps at...
I have the 10.8 drill driver and the impact driver mk2. Over the last six months they have had a right pasting and have matched everything I have thrown at them.
I am refurbishing my house at the moment and the the impact driver is removing slot head screws 4" long and 20 years old as if they...
Looking at that grain pattern it could be sweet chestnut. Very similar to oak but slightly lighter in weight and machines easier.
All other characteristics are the same ie tanning etc.
Les
My hobby has always been woodwork, very basic in the early years but more complex now.
But after forty odd years as a mechanical engineer, it is impossible to get out of the habit of using the tolerances as used in engineering.
It drives SWMBO nuts when I am annoyed something does not look...
If your CU has earth leakage rcbs, then you can loop a spur off the ring main and connect the bath through a fused spur box (the box can be in the bathroom as long as it is unswitched) . If not, you need to connect the spur through an earth leakage rcb then to the bath.
Part "P" could also be...
Mike
Mine is the 01332 10", I do not have the sliding table as space was a problem. I made up a sledge for cross cutting but I also have a Makita 12" sliding cross cut.
There has been no problems at all with the SIP and it runs happily off a 13amp plug.
Les
When I was looking to replace my triton setup for a table saw I narrowed it down to the record or the SIP. I was able to compare the two side by side at a shop in Mitcheldean called Toolite.
The SIP won hands down and has been in my workshop for a few years. It is not noisy and has done...