Recent content by guyandzoe

Pete, I think someone once said that the best tool to use for any job is the one in your hand.

Glad to see you've got it going Ok. Its just infuriating when it wont go right and you cant understand why. I think the sharpening thing is one of the most difficult bits of turning when you set out.

I have the slow creusen and can recommend it. I also have a high speed 8 inch record which did me proud when I thought i couldnt afford any better. I am a bowl turner and have never noticed any difference in 6 or 8 inch wheels except to say I think a 6 inch wheel gives a bevel that rubs less and...

Well said that man!

I wouldnt worry too much about uneven wings on the gouge unless one starts to get in the way. Mine are never the same and it makes no difference - to my bowls. I see you have ordered new wheels so this bit of advice is probably no good now but your grey wheels are also likely to be far too...

I dont have an opinion either way. I have very very few failures either with a spigot or with a recess. Much less than one per year of either. BUT you do need to have a good understanding of your wood and your chuck and not put too much chuck pressure on any recess one makes. The success of a...

Oakbear. Thing is they fill these dos (as far as I am aware) so the price does not limit attendance as far as the AWGB is concerned. Presumably they couldnt accommodate everyone if it was cheaper.

OK. I have had both a DC motor and three phase motor via inverter on different lathes, both on electronic variable speed. Neither ever required maintenance neither lacked torque that I could tell for their size. My opinion is that if Janos is correct this is no reason not to buy or be put off...

Dont be without variable speed! It can be done without variable speed and of course it has been done for millennia. But there are no disadvantages to variable speed and the advantages are legion. I would say that, in modern turning, it is essential in a professional studio. (That should get a...

Bril I like the way you have not flinched from letting the bowl crack madly

Ouch. That must throb! On horror stories... many years ago on a farm a worker I knew was using an angle grinder on the floor to cut some angle iron. You know, the old down on one knee stance. Apparently the grinder caught and pulled free of his grasp and shot off across the floor. Coming to the...

Those chatter marks are the result of the thin wood at the rim vibrating. The tool, or rather the pressure you exert on it makes the wood distort and spring back, a situation that gets worse and worse as the tool bevel passes over the previous poor cuts. Sharpen the tool. Use your fingers...

Be aware though that there are lots of concerns in forum world about the quality of record products and their after sales service and after sales advice.

Thats a good effort for first time. i would advise you to try to cut bowls with the gouge and use the scraper as little as possible. But as you see for yourself anything that ends up with a bowl is an acceptable method. How you get there doesnt matter so long as you are satisfied with the...

I have a VB and can stop that too. It has a 2 horse motor and they nowadays have a 3 horse as standard ( I'm not jealous). Just depends on how hard you want to work it. There are a number of lathes like the VB, graduates (a bit small) general(?) wadkins that are Dalek like and give good all...