Hi all,
I need some help with my table saw. I have the ferm 250 saw and was looking to MOD the top.
Can I make a new top from a board? Eg; chipboard or ply?
I want to place the new top (to make it longer and wider) onto the ally top of the saw.
Would this cause a problem?
I need info about the riving knife and the way the original top is made to take away waste.
Room is an issue in my shop/garage, so could I make a removable one?
It's not the most expensive or top of the range model, but it seems to be ok for a newbie like me.
Any advice?
Thanks.
I need some help with my table saw. I have the ferm 250 saw and was looking to MOD the top.
Can I make a new top from a board? Eg; chipboard or ply?
I want to place the new top (to make it longer and wider) onto the ally top of the saw.
Would this cause a problem?
I need info about the riving knife and the way the original top is made to take away waste.
Room is an issue in my shop/garage, so could I make a removable one?
It's not the most expensive or top of the range model, but it seems to be ok for a newbie like me.
Any advice?
Thanks.