Quick house name carve

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

doctor Bob

Established Member
Joined
22 Jun 2011
Messages
5,171
Reaction score
1,881
Quick and simple, delivery drivers were getting fed up after 2 years of no clues, so finally decided to get on and do it.

3KvpIPt.jpg


OdqBujA.jpg


YhfQKRs.jpg


yUAKgts.jpg
 
printed out and spraymounted on the gate, then freehand with a 45deg bit in 1/2" router.
The secret of any freehand work (router, jigsaw, bandsaw etc) is just to keep it moving, stopping and starting shows up really badly, even if you wander of by 1/2mm just keep going.
Could have done it on a plate and screwed it on, but that would be cheating, just got to go for it.
Spell check is important
 
Bob, funny enough, I did some tryouts a while back ( just my kids names for their doors type thing as an experiment) Freehand in some salvaged pine bed slats from my lasses old cot as a test. Pine was pretty tight grained. Good quality .
Is it my imagination but I just hand drew the letters on in pencil, 1/4" flat bottom bit, bit of fun but I found it much easier to rout the letters in reverse from right to left. First attempt I did it as I would write. When I tried it the other way It worked much better.
Anyone know if there's a reason (rotation of bit/cut etc) or is it just a case of my innate genetics favouring my cousins cuddles? :shock:
Nice gate btw Bob...

Cheers.
Chris
 

Latest posts

Back
Top