lathe arbor

[david]

hello all
i havent been on for quite a while and hope you will help me with a problem as you have done in the past,
here goes,
i have a clarke cwl 30 rv lathe and would like to put a arbor and drill chuck into the tail stock the problem i have (dont like saying it)is is it mt 1 mt 2 etc and also i do not know really if the tail stock is adaptable for this kind of venture.
hoping for a reply.
best regards
david.

 

[CHJ]

You can check the size of the morse taper by checking the dimension A (the open end)
HERE

 

[david]

thanks a lot chas
very nice of you to get back to me with that info
regards
david