Alie Barnes
Established Member
Ive aligned the headstock and tail, checked, double checked and triple checked my centering. However all my cylinders end up the same way. half (always at headstock end) will be a cylinder after roughing, the Tail stock end will always be of wobbly and never a true cylinder.
Im so frustrated that its not worth even trying to make anything at the moment. im currently making a new bench of sturdier construction, im hoping this will sove the problem but im not convinced. Piece of work is only about 12" this shouldnt be too long to cause this problem. Anyone have any experiance of this type od problem. Possibly my bench isnt level, i shall be checking it in the next few days, could this be causing my issues?
Any help is needed as im at the end of my tether on this particualr problem.
Im so frustrated that its not worth even trying to make anything at the moment. im currently making a new bench of sturdier construction, im hoping this will sove the problem but im not convinced. Piece of work is only about 12" this shouldnt be too long to cause this problem. Anyone have any experiance of this type od problem. Possibly my bench isnt level, i shall be checking it in the next few days, could this be causing my issues?
Any help is needed as im at the end of my tether on this particualr problem.