AA batteries

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Non-rechargeable cells generally have a nominal voltage of 1.5V
NiCad and NiMH are closer to 1.2V
Li Ion are around 3.7V, although can show up to 4.2V when fully charged, and down to 3.2V or thereabouts when discharged.

This can make a difference for some devices.
Also, the maximum deliverable current may sometimes be a factor.

So probably not a good idea to ignore, unless you have all the relevant information.
 
OK your knowledge accepted.

My fuji camera wants 4 rechargeable batteries =4.8 v

It takes non rechargeables if I remember? thats 6v.

What do you think to that?
 
Hi, Devonwoody

Well its a lower voltage so it depends on whether the camera will work at 4.8V
Just thing of it as using slightly flat battery's in your camera.

Pete
 
My old nikon 3.2 meg would use any type aa battery. In the menu section you changed the battery type ie normal/nicad etc. Not sure why because more often than not I would forget to change the setting :roll: It's well over 10 years old and still works.
 
I strongly doubt that you will harm your camera by using rechargeables. If it works, then you will probably not get the same battery life as you would using non-rechargeables, but that would be the case in any event, as non-rechargeable cells pretty much always have higher energy densisty.
So if it works, then I'd say go for it.
I have a front lamp for my bike that takes 3 AAA cells, I use NiMH, but I do get a very limited life out of them. It's not a big problem, as the only night cycling I generally do is to the pub quiz once a week, but if I were going on an all-night bike ride I would take two sets, or fresh dry cells.
The same applies to your camera, if you're going on a long trip to somewhere where you can't buy AA cells easily or plug in the charger, then beware.
 
Rechargeable batteries, having a low internal resistance, can deliver a lot of current if shorted by a fault. Enough to let smoke out of the wiring, so a fuse of some sort is pretty mandatory. Toys etc made on the cheap economise by omitting the fuse, which is safe enough with regular batteries, but possibly a fire hazard with NiCads. Well, that's my theory...
 
I suppose also if I put rechargeable aa batteries in a clock it will run slower (only 1.2v) which was my intention when I posted the thread. (didnt realise that they had that less voltage)

but what about those camera batteries mine are ok on rechargeables but the capacities vary, 2100 , 2900 etc. ?
 
Hi, Devonwoody

Your clock has a crystal in it to regulate the time, otherwise it would get slower as it runs down.
It will work fine with a rechargeable.

The higher capacity battery's will last longer in your camera.

Pete
 
Not all rechargeables are equal. If you put a NiCad in a clock, it would run down by internal discharge before the clock had drained it. That's why you must not use them in smoke alarms.

However there are newer sorts which keep their charge much better. Maplins sell them as 'Hybrid' and they come pre-charged in the pack. The big advantage is that you can keep them charged up ready for use, without finding that they have gone flat in storage. Nominal voltage is 1.2v.
 
devonwoody":28z921tr said:
I suppose also if I put rechargeable aa batteries in a clock it will run slower (only 1.2v)

Only if it's the world's most poorly designed clock.

:lol: :lol: :lol:

BugBear
 
devonwoody":2amew1nl said:
And Andy, do they have numerous recharge cycles when in use?

I don't really know. I bought some a couple of years ago, mostly to use in the WiiMotes, for which they have been ideal - much better than NiCad or NiMH. Easy to have a pair in use, and a replacement charged up ready to swap over.

It's these that I'm talking about - doubtless available elsewhere for less:

http://www.maplin.co.uk/hybrid-the-next-generation-rechargeable-battery-219932
 

Latest posts

Back
Top