Search results

that would do me nicely Phil if still available where a bouts are u

I am trying to revive a wooden floor, how do I sand this and what finish should I use after? thank you petra

would I be able to use tung oil on my wooding floor after sanding it??

Hello All can anyone tell me how to get a wooding floor back to live after it has been scratched and patchy polish and beeswax on it I assume sanding it down would be a good idea what sandpaper do I need and what should I put on it once back to the bare wood, I do not want a shiny floor can...

thanks a lot , you have been some help Morris

Hello All would anybody know where I can get a 10 ins sawblade for my SIP panel saw?? it is 254 mm diameter with a 25.4 bore I have tried everywhere with no luck I live in the North East of England thanks Morris

thanks for the tips on the outfield table job done works atreat and space saving the brackets are now out the screwfix catalog and igot the last of two sets up here so thanks again

Hello John I have found them thank you Morris

Hello John thank you for that I had a look, joined up and still cannot see them, where do I go wrong?? thanks again Morris

Hello all I looked at some photos of a outfeedtable for a bandsaw made out of some kitchenworktops, when I looked back the photos were gone can anyone tell me who made this table?? thank you in advance fo ryour help Morris

Hello John I got a Sip 10 ins table saw the same as you and liked the idea of the folding out feedtable. Wanted to have a look how you have fixed this , but the Photos have gone Could you send me them again to have a look at thank you in advance Morris

Hello All thank you for the comments John do you know which cutter I should be buying to pierce the wood and cut a pattern into it?? after only turning 1.5 years I have a lot to learn , but I am sure I will get there thank again Petra

Hello All thank you very much for the compliments, after only turning one and a half years I think I am doing ok, but I have a lot to learn yet I used the dremmel and the ballpoint cutter for this effect. Does anyone know which cutter I should use to pierce the wood and cut a pattern into it...

all the best for the new year everyone please can I have some critics I got the dremmel for Christmas and had to try this Petra

I wish everybody all the best for the New Year what do you think about my bowl, on which I tried to use my new Dremmel, one Christmas present Petra

Hello all this will give me something to think about. Has anyone had something to do with the potbelly stoves in Machinemart, they seem okay or should I just go up the allotment?? thanks again for all your replys Petra

Hello everyone has anyone got a stove from the hot spot, which always advertises in the woodturning magazine I am thinking of putting a woodburner in the garage/workshop?? thanks Petra

Hello All just to let you know how I got on at the craftfair I really had a good time even when only 10 people turned up. I sold a bowl, an apple and a pear and was very proud of myselfe. I have been to Harrogate at the weekend and got lots of ideas for bowls, colouring and drilling holes and...

Hello Andrew the small fair is called the ladys night and is held at the cricket club in Bishop Auckland on Thursday night Petra

Hello all thank you very much for your reply to these candle holders, my friend brought a picture from a Marks%Spencer brochure where they are offered for a fortune I copied the design and already sold 4 sets of them. they not fancy but plain and a bit modern. I must say if you bundle them in...