Recent content by Mouse

Here one I made earlier blade-tidy-t39630.html Full description further down the thread

Hi Edwin, Reverse blades have some teeth facing upwards, perhaps 1in4. Others have some of the bottom teeth facing upwards. This gives a clean cut to the underside of the piece. http://www.mikesworkshop.com/ Check out mikes website, it has everything you ever wanted to know about blades.

The website shows Bernhard sells blades under many different names but he does not sell under the Flying Dutchman name. I personally deal with Mike his blades are the best and his service is second to none.

Never heard of this make but the specs are good, with that amount of discount I wonder if it is end of line. If I was in the market, I would snatch their hand off.

Hi Serito and welcome to the forum. I have the SIP and find it a nice little saw. It is a slightly refined version of the Axminster AWVFS. If you do a search of the forum I did a couple of write ups on it

I get my ply from here: http://myworld.ebay.co.uk/alwayshobbies/. Top grade ply. I buy a selection in bulk and save on the p&p. Delivered in 48hours.

Its fine here,make sure you are logged in Really nice piece of work.

Hi Harry, If you would like to send it to me I will upload it for you

Whats hard about filling in a short form online, then waiting 5-7 days for the blades to drop through your letterbox.

Hi Harry welcome to the forum. I am just down the road from you and can find nowhere local. I use BB ply that I get from ebay.

Hi Jim and welcome to the forum. The two saws you named are among a number of tiawneeze clones? I have the SIP variant of them. The main difference between them all is the colour of the paint job. I am very happy with my saw but made a couple of mods to make it easier to work with. I normally...

Almost all saws take the same length blade (5") or metric equivalent. Check out Mikes website for types and tpi and their uses as this will depend on what you are cutting He only sells pinless which is what most scrollers use. Mike does a trial pack of the most common blades that is a good...

Mikes Flying Dutchman are the best there are,they cut better and last longer than any others I have tried. When I have ordered from him they arrived in 5 working days,postage at cost about $2 He only does pinless. http://www.mikesworkshop.com/

I know Mike has recently had surgery so may be a bit slow in responding while he catches up. According to one of the US forums he is definately still trading.

Hi Jennifer, I would try a little more tension, also check your feed speed is not to high and the blade is flexing. HTH