drill bit sizes

[Phil Pascoe]

a useful table -
http://www.hutproducts.com/images/DecimalEq.pdf

 

[AES]

Thanks Phil. Very useful. I have several actually, but this one is the only one I have that brings the various possibilities all together in one place. Printed out already.

 

[Blockplane]

Thanks Phil, have just printed one to stick up in the workshop.

 

[CHJ]

I wonder why they did not list Number drill sizes lower than 1/8" perhaps the commercial sector they deal with does not work with the finer sizes?

 

[AES]

Yes, I wondered that too Chas. But I have a numbers/letters chart which shows inches/metric too but not the rest of it like Phol's).

Would you like me to scan it and post it here?

 

[CHJ]

By all means post it Andy if you think it useful, although I find the chart I made up (linked in above post) is my 'Shed' go-to to save getting the books out.

 

[AES]

OK Chas. I've seen yours (!!) ;-) and printed it. Thanks.

Now here's mine (.pdf and .jpg):

Only difference with mine is that it all goes on 1 page, so ideal for sticking on the wall, etc.

Hope it's useful to someone.

 

[CHJ]

Thanks Andy, yes that's a problem with my interactive HTM files they were formatted for computer display not printer friendly single pages.

Edit:- page layout modified, should print on one page of A4 now.