Recent content by HeliGav

have you read the reviews on the site, a mixed bag really and sounds like the laser is bait dodgy.....

Worst tool I had was a Axminster bandsaw £800 down the drain.....bearing blade guide poorest I've used near impossible to get an accurate cut time after time, started to rust around the door hinges (something that as never happened to any of my other tools, always well looked after), just...

I'm looking to buy a mitre saw and I need something that will cut 100mm depth and is accurate, wouldn't mind a laser guide on it aswell......If anyone can give me any recommendations of who have had experience of using the tools would be grateful. :?: :?: Thanks (hammer)

Hi guys, I am going to build a camping pod. Does anyone seen any plans available or books on the net. I know it's only a glorified shed, but want to get all the insulation and ventilation etc. right. And make it a it more contemporary. Cheers

Hi can anyone offer advice on a decent finish for drinks coasters, there going to be made from oak, walnut, beech and maple cheers.

It was a joke LOL

They are good, they picked up an item i had from them took it back the factory, sent it back to China to be reparied and returned it to me 12 weeks later. Cannot fault the service. LOL

Might have make it abit bigger for my lady lol thanks guys, think ill go down the clamps and glue route until i win the lottery and afford a domino machine!

mini coffee table... I don't have access to a domino not that rich unfortunately! what size dowels would you use and could you point me in the direction of a kit or something??? thanks

The rough dimensions of the wood pieces are 69mm, 69mm, 275mm. what do you think is the best way to secure them to each other, would glue alone be strong enough? a single screw in each corner can allows it to move which was annoying. any ideas welcome..

Im going to be carving out signs in oak for a friends house. which paint would you use which is durable for the letters? I'm planning on using danish oil or a uv paint I've been reading about. I'm just stuck with what paint to use for the letters?

Thanks ill check them out and see how i get on!

does anyone have any links to websites that sell them or companies? I've been using sanding sealer before using sharpies to colour in but nibs soon get damaged and had some small bleeding.

Im carving out signs and want an easy way to colour the letters in. Can anyone recommend which would be the best type e.g.. sharpie or is there a special pen for the job?

they all awesome! so will the inventables spindle take a larger collet or do you have to upgrade the spindle to use 1/4" router bits. can anyone show me a link of which to buy to connect to the spindle to take the 1/4 bits?