Wiring DOL starter

[crt]

I wonder if anyone can help with this wiring query?

I'm replacing the burnt out motor on my old table saw with a new Clarke motor from Machinemart, and the warranty requires that it is wired through a DOL starter as shown in this link:

http://www.machinemart.co.uk/shop/produ ... 6-3-10-amp

I assumed it would be straightforward but having opened the thing up it is not at all clear to me where the wiring goes.

Anyone have any suggestions?

Thanks.

 

[Slim]

Hi crt,

I can't help you with your wiring, but here is your link. (Caught by the spam trap)

http://www.machinemart.co.uk/shop/product/details/dol-starter-6-3-10-amp

 

[9fingers]

There should be a diagram with a new switch?

They are all more or less the same.

A minimum of three switches on the solenoid. One maybe smaller that the other two and is in parallel with the start button. Stop button is a normally closed switch in series with the coil.
The other two ways control the motor.

I see if I can find a diagram on line and post a link.

Bob
EDIT>
Try this http://www.pdlglobal.com/data/product_d ... cument.pdf
page two, bottom left hand diagram for single phase.

 

[crt]

Thanks. The instructions you posted the link to are far clearer than the ones I've got but they don't seem to tally.

If I knew how to post a pdf link I could post a copy of the instructions I've got. Is this possible on this forum?

[/url]

 

[9fingers]

You have PM