After some tips etc...
Kitchen fit next week, Wren. Worktops have already gone back as they're of very poor quality, dinks and dents all over them. But that's another story...
Wish I could use sketch up or similar. Picture this, I have a run of 600mm wt along a wall joining at 90 degrees to a 900mm wt with a standard 1000mm unti under it. The over hang will be a breakfast bar scenario. They want a piece of 900mm wt as an end panel, so a very long mitre. Any tips on this? I've done the same but with 600mm. I have festool plunge saw and clamps. Do I biscuit joint it? Screw and plug? Go an buy a Domino?
Cheers guys, I'll take pictures of this one and how I go
James
Kitchen fit next week, Wren. Worktops have already gone back as they're of very poor quality, dinks and dents all over them. But that's another story...
Wish I could use sketch up or similar. Picture this, I have a run of 600mm wt along a wall joining at 90 degrees to a 900mm wt with a standard 1000mm unti under it. The over hang will be a breakfast bar scenario. They want a piece of 900mm wt as an end panel, so a very long mitre. Any tips on this? I've done the same but with 600mm. I have festool plunge saw and clamps. Do I biscuit joint it? Screw and plug? Go an buy a Domino?
Cheers guys, I'll take pictures of this one and how I go
James
