I want an 8" bench top table saw (not that critical actually), with a cast iron top (so I can use magswitches), induction motor (quiet) and standard 3/4" mitre slots (so that I can use the same mitre gauge on my bandsaw and table saw). Am I asking the impossible? I dont need it for a lot of tasks, so just want to lift it onto a stand/bench/workmate as required. Any ideas?
Is there enough meat on the Axminster ts200 to have the mitre slot machined out to 3/4?
Is there enough meat on the Axminster ts200 to have the mitre slot machined out to 3/4?
