Sip table saw wont keep running

[Joecobbs]

Hi,

I have a sip 01918 table saw which has been fine for the few months ive had it, but I went to use it today and it will not keep running after I've pressed the green button. It keeps going if I hold the green button down but if I let go it just stops.

Like I said I've only had the saw a few months, anyone else had this problem or should I just return it?

Cheers
Joe

 

[Mike.C]

Hi,

I have a sip 01918 table saw which has been fine for the few months ive had it, but I went to use it today and it will not keep running after I've pressed the green button. It keeps going if I hold the green button down but if I let go it just stops.

Like I said I've only had the saw a few months, anyone else had this problem or should I just return it?

Cheers
Joe

No brainer Joe return it and do it sooner rather then later.

By the way welcome to the forum

Cheers

Mike

 

[9fingers]

Almost certainly sawdust in the NVR. These can be opened with great care or maybe just a blowout with a airline will sort it.

Either that or change it for a new one from SIP. Make sure you make an accurate note of which wire goes where.

Bob

 

[kirkpoore1]

See if your stop button is stuck down. The stop button on my TS snags on the housing sometimes and causes those exact symptoms. (Of course, mine has a 3 wire control on a mag starter, and yours may have something else entirely.)

Kirk

 

[humblewood]

I had the same issue with a 4 month old Axminster bandsaw a few weeks ago. A quick phone call to Ax and a replacement switch was in the post. Just swopped the wires over one at a time to avoid overtaxing my small brain, and it was working again within a couple of minutes. Simples