sip 10" cast table saw + Blades and Dado cutters

[hunggaur]

Sip 10" cast table saw with extras £1000.00

It is with a heavy heart I have decided to sell my sip 10” cast bed table saw due to ill health
The saw is single phase and has been adapted to take additional smaller blade bores down to 16mm.

The saw will still take the standard 25mm bores, 30mm bore as well as 16mm bore

This is great bit of kit and i will be very sad to see it go

It is complete with a selection of 7 saw blades (some will need re sharpening i do have a contact for this)

In addition it also has a 6 inch wobble dado blade and a full Freud dado cutting set which I have only used twice these alone are over £200.00 and are great for cutting groves and dados.

I personally think this is in great condition with no pitting to the bed and had never missed a beat for me.

It has only had light hobby use and is complete with the riving knife blade change tools , saw guard and selection of homemade inserts for use with the dado blade

I have also mounted the saw on lockable casters so it can be mover around the workshop as required

Whoever gets with won’t be disappointed.

To buy this lot new would cost over £1500.00

collection only Stourport on severn

#

 

[MattSancho]

Hi there, I'm hoping you might be able to give me a bit of advice please re. your dado cutting stack please? I've just bought a 10" Sip table saw (looks to be the same as yours, I think) I need to cut a rebate joint into 150 @ 3/4"x7"x 10' lengths of larch for a cladding project i'm working on. Here's my question did you have to make any modifications to your saw to accommodate the dado set? i'm thinking of buying a 8" Freud set similar or the same as yours, I don't have a spindle moulder or a bid enough router to make the cut, so i'm looking for a way to use my saw... Any advice you can give would be greatly appreciated.... Many thanks Matt

 

[hunggaur]

yes the spindle on the sip used to be 25mm ( they may have changed it so check the size) as mine was 25mm it had to be turned down to 16mm and then it would take the 16mm dado blade. if teh spindle is 30mm it will take a standard 30mm dado set.