My Latest Router Table

[Titus A Duxass]

I finished construction of my knock down Router Table this weekend.

Just need to seal the mdf and build a sliding fence.

So far it's cost me less than 50€ (including the phenolic insert plate).

 

[devonwoody]

Looks good.

Are you planning a sliding assembly of some sort?
Routing crossgrain pieces I find demand a 90 degree set up that slides past the cutter.

 

[Titus A Duxass]

Yes, I'm building a Sliding Fence.
This is one for my other table in the box joint mode.

I'm going refine this design but improving the dust/chip extraction, making the width adjustable (1 or 2 mm) as it sticks in the summer and is sloppy in the winter.
I'm also going to try and incorporate some anti-lift system to prevent lift out/up when cutting laps or v-grooving.

Here's a short video of it in action cutting lap joints.
http://s269.photobucket.com/albums/jj50 ... CT3325.mp4

 

[worsley947]

Hi that looks good where did you buy the phenolic insert plate from
As I need to buy one for the router table that I am making
Thanks Dave

 

[Titus A Duxass]

I made the plate, I can buy Phenolic Sheet (HPL Platte as it is called over here) from the German version of B&Q.