ByronBlack
Established Member
I thought I would offer this to the forum before it goes on the bay.
Since I got it last week, I have sourced a replacement switch (fully working) cleaned up the beds and ran some test pieces through it, i've not adjusted the beds yet, but could do this if the potential buyer wishes.
I don't know the exact value of this item, it's nearest comparison I'm guessing would be the Axminster 6" jointer.
This one comes with an chip-catcher (bucket), a fence add-on and a removable guard.
It's a two-knife cutter block model, the knives could use a sharpen, I could probably do this to a basic level.
It's in fully working order, clean, quite easy to shift (with a sack trolley or similar) will fit into the boot of an estate or hatch back car.
I have a rough figure in mind, but it's open to offers.
I will be glad to answer any questions that you might have.
Pics:
Since I got it last week, I have sourced a replacement switch (fully working) cleaned up the beds and ran some test pieces through it, i've not adjusted the beds yet, but could do this if the potential buyer wishes.
I don't know the exact value of this item, it's nearest comparison I'm guessing would be the Axminster 6" jointer.
This one comes with an chip-catcher (bucket), a fence add-on and a removable guard.
It's a two-knife cutter block model, the knives could use a sharpen, I could probably do this to a basic level.
It's in fully working order, clean, quite easy to shift (with a sack trolley or similar) will fit into the boot of an estate or hatch back car.
I have a rough figure in mind, but it's open to offers.
I will be glad to answer any questions that you might have.
Pics: