Finally got round to it,

[joethedrummer]

Hello Woodspinners,
Got to giving the bench a tidy up during the week and found a little coarse thread screw and remembered I had saved it for a bowl depth gauge I was going to make sometime.
Well "sometime" occured this morning and along with the afore mentioned screw I found a nice piece of old school science room mahogany worktop and the depth stop rod from a long ago defunct bosch drill and they all came together to make said bowl depth gauge.
Now I know I could have bought one for the cost of the time invested but this one is "mine".
I just love a bit of that recycling, makes you feel right good.
,,,,joe,,,,

 

[MARK.B.]

Nice one Joe =D> =D> =D>

 

[Grahamshed]

Have to make myself one of those.

 

[gregmcateer]

Very nice, sir

 

[SimonT]

Nice job!! Been on my list for a long time too, along with a jig for max / min chuck sizes and finishing all those jobs around the house. Might happen somtime this century (but most likely not) lol

 

[Spindle]

Hi

Two rulers work for me :wink: :wink:

Regards Mick