can someone make me a bolt??

[stevebuk]

my delta scrollsaw tighening bolt has snapped and short of having to find one in America i dont know what to do about it. I will take a picture to show it..

will happily pay.

 

[Spindle]

Hi

Why not buy a suitable coach bolt - cut the head off - file a flat or two and bond on the handle with epoxy?

Regards Mick

 

[katellwood]

would a male one of these do, if the handle can be positioned out of the way and subjective to the thread i.e. is it metric

http://www.axminster.co.uk/axminster-ax ... rod864163/

 

[stevebuk]

thanks guys but it looks like i will have to go to the murricans for help, i have the loan of a hegner until mine is fixed, might be a while yet.. :wink: :wink:

 

[Jonzjob]

We used to have a dog that could make bolts. Every time she pood on the floor, she made a bolt for the door :mrgreen: :mrgreen:

OK, I'get me 'at

 

[CHJ]

Steve, unless you put up the dimensions, thread form and diameter it is difficult to offer any advice or possibility of making a replacement.

 

[9fingers]

Chas is correct.Whether you by or get someone to make one, you must produce a spec

You can buy single bolts of British, Metric and Unified threads here http://www.emkaysupplies.co.uk/

Bob

 

[Doug B]

Just bring the bolt over sometime Steve, If I`ve not got one on stock I can get you one in a day or so.

 

[stevebuk]

thanks again guys but i will be ordering the parts from america.

steve

didn't see your post before this doug, i will save the bolt and see what you can get..