MMUK
Established Member
Half way through routing some worktop joints yesterday and suddenly the plunge froze. In order to carry on working I had to use the micro adjuster to plunge. However, it wouldn't raise back up after - I had to wind out the micro adjuster and tap the base with a mallet.
The stanchions are clean and there's no lateral movement. I've soaked them in silicone lube and it freed them up for a short while but now it's gone really stiff again.
Any ideas anyone? The router is only a few months old and this was only it's second outing.
The stanchions are clean and there's no lateral movement. I've soaked them in silicone lube and it freed them up for a short while but now it's gone really stiff again.
Any ideas anyone? The router is only a few months old and this was only it's second outing.