Search results

Thanks again Roy. I'll take a good look at the Axminster then - I need to measure my table saw as it has an extension to the right of the blade so I want to make sure it's wide enough. I think I would go for the extended fence, probably just because it's what I'm used to, although I'm not sure...

Hi Roy, Thanks for your prompt response. I've seen both of these before, but to my eye, they don't look particuarly meaty. the kreg doesn't have a cambered lock off and twisting the knob to tighten it would quickly get on my nerves. Similarly the axminster unit looks too small for a decent...

Hi all, I have a SIP 01332 and the fence is tired and as it locks at the back, it is prone to drifting from true if i'm not super careful when locking it down... I'm looking for a good quality replacement fence that front locks rather than at the rear. I've seen the Shop Fox W1716 but that...

Hi all, I've had my SIP 01332 Table saw for 3 years (it was alreasy 2nd hand when i bought it). It's aproper workhorse and is used regularly fro my hobby... Lately though, it's becoming tough to raise the blade. I've cleaned out the inside as much as possible but to no avail. I have to put a...

Hi, Seen this on Toolstation for under £1,500. 3hp motor which I'm prettty sure wil resaw well enough for my needs as well as other things. Do any of you have experience of these? I have an old SIP table saw that is built like a brick outhouse and has served me well. Any thoughts? or theres...

My (utterly rubbish) Fox bandsaw has finally died and I'm looking for a replacement. Rather than heading to Axminster / Rutlands etc, I thought I'd ask you wise sage's advice first...I have heard that a lot of the far eastern importsd that are sold by these guys can leave a bit to be desired...

Thanks all for your help. Got what I needed from Axminster in the end so all good!

I hope this is the correct forum... Can anyone help please. I need to get a new blade for the above RAS. 40 to 60 teeth is fine. I understand that table saw blades are not a good idea but I have no idea where I can buy the correct blade from... Thanks all.