Search results

so the nice lady indoors has granted permission for me to knock down my wood workshop and replace in brick with tiled roof as i live in a residential area sound is my key issue to address,my initial plan was a 300mm cavity wall with 50mm kingspan but im open to suggestions?? single brick with...

yes its me, looks like im jig making

hi guys im after a jig to cut the hole for rafix20 fittings, apart from paying £360 for the hafele jig what other options is there? i dont really fancy making anything if i can help it

if you go to the timber yard you will have a few patterns/styles to pick from, i get my mdf in 5.4m lengths

i changed the design a little and used clip on soft close inset hinges, loads better than butt hinges :)

nice work alan, on your pre making visit how do you template for the slope?or do tou just measure

im building a alcove unit and it is having 2x doors flush with the face frame and will be made from 18mm MR mdf the last one i made i used flush hinges but was not reall happy with the fixing strength to the edge of the mdf so what are my options on hinge choice? ive looked at inset euro...

id get the panasonic 14v twinset, panasonic worked with hilti to produce these drills i believe

ive had my festool drill since 2009 and use it daily (trade use) and the batteries outlast my newer bosch blue both 2.6ah batts

id just buy round toped pales from the fencing centre if i wanted 500

d4 grade pva glue its availabe at tool station

i have one of these http://www.ebay.co.uk/itm/VINTAGE-BRASS ... 3cda832f9e

i would not attempt a mitre like that on laminate, it will have a real sharp edge that will chip easy. if you really want to use the spare worktop as a end panel, cut the end panel down 15mm and fit then fly the worktop over the top and add a edging strip.

gwr thats was my first real attempt at spraying :P i got the earlex hv4500 from toolsatation for £150, it has the same turbine unit as the hv5000 but the gun is alittle different and comes with a 1.5mm needle id suggest you get some propper sprayable paint from morrells, my very first...

ive had some rubbish from bnq before, i always check now, the last dozen sheets ive had have all been decent, they even had some medite premier. if i find they have a bad pallet i will go somewhere else, but its only £15 a sheet at bnq 23£ in jewsons,

it looks ok when its above head height, i did try a full round over but looking up at it, it looked short/thin and a square edge looked too flat. i will take pics next week when its fitted to the kitchen im building :)

this is what i came up with IMG_2013 by j.j joinery, on Flickr IMG_2012 by j.j joinery, on Flickr

IMG_2006 by j.j joinery, on Flickr turned out great, never got close to this finish using normal paint

i have the usuall selection of cutters, i tried a few combo but they dont look right to me, the one i like the most is ogee then cove then 9mm round over but im not sure….

does anyone have any plans or designs of cornice that i can build in parts on the router table? ive got a selection of cutters but i cant figure out anything that looks decent. im making "country" style kitchen cupboards and need about 3m of cornice. i planned on using 3 0r 4 18mm mdf layers