Recent content by redflex

The bandsaw has a habit of bowing in the middle of the cut, I have adjusted the tension, tracking and the blade guides, to remove this but then the blade does not running smoothly and seems to bind

I am trying to cut small pieces (i.e 50mm x25mm) as well as slight larger pieces (300mmX600mm) with accurate straight edges. I have a bandsaw and a scrollsaw but neither gives the results I need. My budget is very limited around £100 max, I considered the Proxxon bench top saw but that would...

Look for help with finger joints please,, When I close up the joints, the fingers are splitting or breaking off I have tried varying the thinkness of the joint sections no success When I made the joints not so tight it leaves gaps and makes the box look untidy I am currently using...

The stem is 2.45 cm The stem that did not fit was 1" dia

Looking for advice I have just bought a Draper WTL95 and trying to find a short tool rest (100 or 150mm), I have tried Axminster and few other places all have a stem that is just fraction too wide Anyone know of where I can find tool rest to fit or a make that is compatible? Thanks

Thanks everyone Decide go with pcb1962 suggestion, I will be using router table so doing 2 passes with different bits should be straigh forward Cheers

Hi, Just join here first post, but been lurking for a while normally do box work and inlays but sometimes venture into other things. Currently working on a new project and looking for a 1/4" shank Plunge Ball Marble Storage Router Bit, The only one I found is 1/2" one for US but they do not...