Recent content by musomaniac

thanks again bob for ýour patience , could you send some pics to [email protected] ,how can you carry out repeated operations , do you count have many times you turn each wheel , do you have to turn both wheels together at the same time to obtain a diagonal , i imagine that would be challenging...

thanks bob for the info , so,what exactly is it called ? a wolfcraft what ? I've never ever used anything like this before , is,there projects to have a go at ? what do,you,use it for bob , have you any photos , ? sorry for all the questions but i'm trying to decide if i'll ever use it

The reason I ask is because I can't find it anywhere on the web, I've searched Wolfcraft pillar/milling table/machine x-y table etc ect and I can't find anything

Thanks for that, not quite what I was after though

I also have the router which fits as well, would anyone know what I would likely get if I was to sell it

please try links again

Just acquired this , has anyone got any info on it , I've never had or used one before https://drive.google.com/open?id=0B1bKf_II7iG9MzE5QWc5OEJrQ2s https://drive.google.com/open?id=0B1bKf_II7iG9RUFQZkJIeExsWVE https://drive.google.com/open?id=0B1bKf_II7iG9dkg3ZkFlUEZzWVU

Thanks Naznomad , I reduced the thickness of the stock and its much better

Hi ,I have a Hegner single speed scroll saw , the table is perfectly square to the blade, but on cutting 2inch pine to make scroll saw boxes https://onedrive.live.com/redir?resid=8 ... hoto%2cpng The cuts are not square which makes it extremely difficult to release the centre of the box, I have...

Hembsy where did you get the holder for the dti , or did you make it ? if so how ? I've noticed on thicknessed stock that one edge is thinner than the other , i would like to determine if the rollers are level (is there any adjustment on these to set them perfectly level) ... and also to check...

its not a solid tip machine , it uses wire

I have just aquired a janik g4hw , its a hot wire pyrography machine , I'm just wondering where I can get tips for it

thank you , timber , that pdf was very helpful

now that I've set up my dovetail correctly , I'm ready to have a go at making a box , does anyone know what the proceedure is for rotating the boards once the left and right pins and tails are cut

sorted , I just moved the vertical stop small increments at a time until the boards were aligned