Recent content by KJ2

Thank you @Sideways for your detailed reply. I spoke to my neighbour this evening who suggested we may be able to craft a replacement but will also follow up on your recommendation for NMA. Very kind of you and much appreciated.

Evening all. I have been given a Kity 637 P/T from a neighbour who himself inherited it from a fellow woodworker. It's clearly been a while since it has been used, so I'm spending time cleaning it up, but as I am not technically minded, it's one careful step at a time. Before I run anything...

Also interesting is the wall to wall news coverage when compared with last week's loss of some 750 lives.

All good advice, and thank you all. I'll drop the idea of wearing gloves around machines and only use for handling. @heimlaga as for working in freezing conditions, my neighbour is a woodworker and now 72. He explains the loss of two fingers down to the numbness caused by working in cold...

Thank you again for taking the time to advise.

Thank you for your advice. I'll look into both the 3Ms and Marcator; the latter of which could be useful when handling the bees, where I tend to use Marigolds.

I have noticed that some YT posters wear gloves whilst working, which makes sense to me if they are gripped and to prevent slippage. Are there any particular brands that you would recommend? Thank you.

Morning all, following earlier advice here on another project I borrowed a belt sander from a neighbour to clean up an ex-school Emir workbench that he had given me. Made a huge difference compared with my small Makita RO sander. I now have to tackle the outside of the 5x5 metre workshop which...

Thank you all for your kind advice. Now resolved with PCL XF fittings. Not sure why Hyundai supply two pretty useless hose connectors (ie male connectors, that fit into an unconnected hose), but there you go. Thanks again

Thank you @ajs for the time you took for such a detailed reply. 35 miles to the nearest Machine Mart but found a place in Yeovil that looks like a good source.

I took delivery of a Hyundai 24l compressor and have ordered a silverline 18g air nailer but am confused about the air lines and connections that go between. Euro connectors/ 1/4 inch etc.... Any advice would be appreciated. Thanks

Thank you for that tip @Transit80 . Bought mine (A+) all in original packaging for £100, delivered next day. Now just need to figure out which hose and fittings go with it. Just ordered Silverline 868544 as well, so should be all set up pretty soon.

Hi Rob, I too would be grateful for a PDF copy of the manual. About to be given one. Thank you

postcode?