Recent content by Joecobbs

Hi, Does anyone know of any resource that shows how to make big traditional moldings using multiple router bits and joining them together, or is it just a case of experimenting? I've tryed searching but can't seem to find what I'm looking for. Hope this makes sense.. Thanks

Thanks for the reply. So, if I went for the Axminster style one, I wouldn't need a cyclone? Is the Axminster type right for a table saw and router table? Also, I have a wickes wet and dry vacuum, would it be worth making a cyclone for that, for hand power tools?

Hi, about to start looking at dust extraction for my converted cellar workshop, and I'm getting a bit confused about what's best to have. I have a table saw and router table and assortment of power tools. I'm wondering what is the difference between this type...

If I've got the reasoning correct its because the ends dry out and shrink faster than the middle, so the ends are pushed together in a spring joint to counteract this? It's basically to keep the ends from separating over time. I think...

Hi, I'm about to make some drawer handles out of some African Blackwood. I was wondering how to finish them? Obviously the handles will get a lot of use so I'll probably need something tough, and I've never used this wood before, so wondered if there's anything I need to know about finishing it...

Hi, I have a sip 01918 table saw which has been fine for the few months ive had it, but I went to use it today and it will not keep running after I've pressed the green button. It keeps going if I hold the green button down but if I let go it just stops. Like I said I've only had the saw a few...