Recent content by Dave-Jeffo

Thanks all! As my post was a little bit wollie, Il give a bit more background on what I’m wanting. I currently have a large Startrite saw with full sliding table etc. It’s by far over kill for what I require. (I bought it cheap and got it to a useable/running state) So I’m now wanting...

Good evening I’m on the look out for a smaller size /portable table saw. I have been looking at the dewalt 745 but Someone local to me is selling a second hand Axminster TS - 200 - 2 complete kit including a small shop vac and a homemade cyclone advertised at £500. Is it worth buying...

your pitch should be fine. I agree with the above, if your putting planning in. Why not make it as wide and as large as possible. Dave

How heigh is your roof going to be (to the ridge) and how heigh is your frame work going to be?

Hi all, i bought a rather cheap Ta 300 that needs a bit of work. Its going to be my project so i can hopefully have it up and running properly by the summer. Iv got it running fine so now its time to make it safe to use. when i bought it i was given about 40% of the frame work for the sliding...

Thanks :) I did think of making one myself on the lathe but id have to offset my riving knife the same so wanted to avoid it if possible

So the time has come for me to buy a table saw blade. Now I understand this is like saying what car should I buy. But what/where should I buy my blade. I also understand that you get what you pay for but I'm no professional, so I'm after a happy medium. As me and alt can't quite decide wether...

Hi, I have recently purchased a Startrite table. After a lot of research and speaking to a few different people from alt I believe the model to be either 255sp or a 300sp. If people could post some pictures of there current Startrite with a couple of close ups of the fence system that would...

Thanks, I shall look into that.

Brilliant, thank you very much! Cheers Dave

Thank you to everyone that has commented! I have now managed to windle the model down to two. 255sp or a 300sp. Unfortunately the standard parts I need are no longer available. So I'm on to the case of sourcing some retro fitting parts. Let's see how this goes. Cheers Dave

Thank you very much! looks like it's a job for Monday then.

Thanks for the reply and link mat. I've already had a brief look at the site, it looks great. but wasn't sure on my model to look into depth. Sorry about the rubbish pictures I had to lower the res as the file was too large. The plate says - Serial no. 104230 Volts 240v Phase 1 kW 1.5 No...