Recent content by TH26

Thank you all for your replies. I think I worded it poorly when I said my workshop wasn't capable as to be honest I don't know if it is, what I meant was it wasn't set up. I think I will look into getting a 16 amp socket installed as like Ali said it will open up more possibilities. It's good to...

Firstly sorry for starting another table saw thread. My Elu TGS 172 has packed up and I've spent the past 2 weeks looking for replacement parts to get it going again but have had no luck. This means I am now looking for a new table saw, I had aimed to upgrade to a cabinet saw but after looking...

Thank you everyone for all the help, it has all been really helpful and given me a lot of things to consider. :D

Someone would like me to make them some drawers to go underneath their TV, the only thing is they want to drawer width to be 1.4 meters and to have push to open runners so there are no handles. For me these seem like extremely wide drawers and not something I have even considered doing before...

Thank you both very very much for the help.

I hope I've put this in the right place. I was wondering if anyone had information on the history of the corner chair or any books that would be worth checking out? I have to write a paper about them and I am struggling to find a lot of information when looking through google, it's all pretty...

I've managed to get it on. Turns out the pulley shaft also screws on as well as has a bolt holding it in place. So I took the front pulley shaft off by locking it with a spanner on the side where the saw blade sits then unscrewing it by covering it in a cloth so I didn't damage the teeth and...

I have tried to remove 56 and 74 but they are holding on very well and I worry about damaging them. I will definitely try warming the belt to see if that helps. Thank you for the help :) .

Yes that's the one. The belt is number 55 towards the top right of the second picture, although they seem to have cut half of it off in the picture. It loops around number 56 and 74 and I am really struggling to get it on.

I have a Elu TGS 172 combination saw and when I was using it yesterday the drive belt snapped. I have a spare but can't get it on as it's too tight, I actually already broke one spare when trying to feed it on. I can't see anything I can loosen on the actual machine to get it on. So I was...

Got your PM but I am not able to reply. Thank you very much for the help I will certainly have a look at that.

Hello, I am look for some advice with getting a planer thicknesser. Due to the limited space in my work room I am after one that isn't difficult to move, so that I can store it out of the way bringing it out when I need it. I have had a look at the Record PT260 but wanted to see if anyone with...

Hello all, new to the board but have gotten answers from here before. I was wondering if anyone could tell me a cheap alternative to real wood veneer. I am just looking to cover a MDF table top, possibly with that plastic stuff like IKEA use. Hope you can understand what I am on about, thanks...