exigetastic
Established Member
Have lots of 16ft 4x2s I'm cutting for my decking project, and not exactly the easiest things to shift single handedly.
What I really needed was some sort of rollerstand.
B+Q didn't have any (apart from a mitre saw stand which I suppose would do for 8ft lengths), and nowhere else was open.
So I went in my shed for a tinker and this is what I came up with
And a close up of the "rollers", which are basically just bits of pushfit pipe cut into small pieces threaded onto a bit of M8 threaded rod.
It might not look pretty, but was free and seems to work fine. Going to use it in anger today!
Si
What I really needed was some sort of rollerstand.
B+Q didn't have any (apart from a mitre saw stand which I suppose would do for 8ft lengths), and nowhere else was open.
So I went in my shed for a tinker and this is what I came up with
And a close up of the "rollers", which are basically just bits of pushfit pipe cut into small pieces threaded onto a bit of M8 threaded rod.
It might not look pretty, but was free and seems to work fine. Going to use it in anger today!
Si